Tricked_out_CB_radio **AF POWER KIT** For CB and Export Radios

Description

** AF POWER KIT**
For all Radio Circuit Boards  as follows:
EPT2950 series
EPT3600 series
EPT6900 series
EPT0929 series
EPT0696 series
Power Amp Improvement
This is the best improvement you can make to Most chassis. The stock device is a 2SB754, which is a 60-watt, 7A power amp device. This does fine for stock radios. However, in order to stabilize the voltage on the board after improving the RF output and boosting the modulation, the transistor in the kit becomes the better choice. The kits transistor is a 100-watt, 12A device which allows greater voltage stability for the entire radio as a whole.  with the stock device you should
notice
bit of wobble and light dimming. After replacement, the radio will respond with almost no blinking, zero wobble and a healthy increase in RF output as well as swing. Replacing this device also allows you to increase the input voltage to 14.5VDC, provided you also replace all the 10V caps in this section of the board to 16V ones.
AM AF Amplifier Improvement -
This is another must  improvement,  The stock AF Amplifier is the 2SA473. Replacing this with the the transistor in the kit will improve the clarity and volume of the modulation. It will also run much cooler which provides stability for the device. If you plan to use the radio  with the provided stock microphone, this upgrade is highly suggested for maximum AM modulation.
Tested and Tried True
Look at Pictures For Actual Condition on INSTALL With Easy Instructions, Simple Replace 2 transistors, Some Soldering
Knowledge
is Required.
For Sale Read My Feedback Buy With Confidence